Installation of liquid heating tube

Liquid heating tubes are widely used, whether it is water heating, oil heating or other liquid heating, liquid heating tubes are indispensable. The shape of the liquid heating tube is different in different use environments, and its installation method is also different. So let's take a look at how to install liquid heating tubes of different shapes.

1. Single-head electric heating tube

  The single-head electric heating tube that heats the liquid is generally a threaded single-head electric heating tube, which is often used to heat water tanks and so on.

The installation method of the threaded single-head electric heating tube is as follows:

A. Drill a threaded hole in the water tank consistent with the thread of the heating pipe.

B. Screw in the liquid heating tube from outside to inside. (There is also a threaded single-end heating tube with upward thread, the installation direction is opposite to it)

2. U-shaped/W-shaped/straight rod/shaped electric heating tube

Generally, U-shaped/W-shaped electric heating tubes for heating liquids use fasteners or silicone indenters.

A. Drill a hole slightly larger than the diameter of the pipe thread on the equipment where the electric heating pipe is installed.

B. Then pass the end with the fastener through the hole, put on the gasket or washer, and screw on the nut.

3. Flange electric heating pipe

  The installation method of flange electric heating pipe is more complicated than the above. Xiaobian I have introduced it systematically before.

There are many ways to install liquid heating tubes. According to the introduction above, everyone should know how to install liquid heating tubes.

Our company's quality products: Flange Cartridge Heater,Electronic Hitter,Teflon Immersion Heater, etc.